Required Tools | |||
---|---|---|---|
Tool | Part Number | Part Description | Qty |
A | 5F-4764 | Pry Bar | 1 |
B | 8T-2998 | Lubricant | 1 |
C | 1U-5718 | Vacuum Pump | 1 |
169-7372 | Fluid Sampling Bottle | 1 | |
4C-4057 | Tube | 1 | |
D | 4C-5552 | Large Bore Brush | 1 |
E | 4C-6774 | Vacuum Gun Kit | 1 |
F | 8T-7765 | Surface Reconditioning Pad | 1 |
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Illustration 1 | g02343936 |
NOTICE |
---|
If the injector hold down bolt is loose during the removal procedure, inspect the injector bore for wear and debris. Replace the clamp and spacer. Prodigy hegelian dialectic download. |
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Illustration 2 | g02343936 |
Illustration 3 | g01135876 |
NOTICE |
---|
When an electronic unit injector is replaced, the new electronic injector code must be programmed into the engine's personality module software by using the calibration menu on the Electronic Service Tool. If the new electronic injector code is not entered, the characteristics of the previous electronic unit injector is assumed. If it is not possible to immediately reprogram the electronic injector code into the personality module software, the engine will not be severely harmed. The new electronic injector code should be reprogrammed as quickly as possible in order to optimize engine performance. |